VOLKTEK NSH-9308P Manual de usuario descargar pdf (Pagina 29)

3.0 Terminal Mode management

Terminal mode is easy to operate; it is useful when in-band Ethernet communication was

malfunction.

No password is needed in terminal mode operation. Set up the terminal parameters, such as “Hyper

Terminal” in Microsoft Windows System before you start the terminal mode connection.

1. Select COM #: COM 1, COM 2 …

2. Set “Baud rate” to 115,200 per second

3. Set “Attributes” to 8, None, 1, None (8 bit, No parity, 1 stop bit, No flow control).

After you login into this system, the basic operation rules are shown below.

Type “?“ and press “Enter” to display usable commands, type “up“ or “ / “ to go back previous level of

commands.

Commands at top level:

System - System commands

Console - Console commands

Port - Port commands

MAC - MAC commands

VLAN - 802.1q (Tag-based) VLAN commands

Aggr - Aggregation commands

LACP - IEEE 802.3ad Link Aggregation commands

RSTP - IEEE 802.1w Rapid Spanning Tree commands

User Group - User Group (Port-based VLAN) commands

QoS - QoS commands

Mirror - Mirror commands

IP - IP commands

Dot1x - Dot1x commands

IGMP - IGMP Snooping commands

Debug - Debug commands

System commands:

System>?

Commands at System level:

1 2 ... 24 25 26 27 28 29 30 31

Sin comentarios

VOLKTEK NSH-9308P Manual de usuario Pagina 29